Troubleshooting
The sync stops partway
Copying a session uses the sensor's own Wi-Fi, which takes far more power than recording. A sensor that recorded all afternoon can still be too low to send its rides. In every case below your sessions are safe: they stay on the sensor until they have transferred.
CHARGE IT FIRST
The app reads the battery before it starts the transfer. At about 10% or less it does not start, and asks you to charge instead. Rest the sensor on the dock for about twenty minutes, then sync again.
Up to 30% the sync goes ahead with one line of warning. If the light goes out during the transfer, dock the sensor and sync later.
DID THE LIGHT GO OUT?
If the sensor was low and then stops answering, the app asks whether its light went out. Your phone cannot tell an empty sensor from a Wi-Fi connection that did not land, but you can see it. Light out: charge it for about twenty minutes. Light still on: the app helps you join the sensor's Wi-Fi by hand.
BATTERY TOO LOW TO FINISH, or YOUR GADGET STOPPED ANSWERING
These appear when the sensor goes quiet in the middle of a download. If the battery was low, the app says so: dock it for about twenty minutes. Otherwise it asks what you saw. If the sensor switched off or turned red without you pressing the button, its battery is low all the same. Then tap SYNC AGAIN.
A cold battery can stop early even when its percentage still looks fine.
SWITCH YOUR GADGET OFF AND ON
On current firmware the sensor does not answer your phone again after a sync until it has been restarted. The app tells you when that is the case. Hold the button until the light goes out, then short press until the light pulses blue, and sync.
Stops every time, even freshly charged? Tap GET HELP or CONTACT US on that screen. The mail the app prepares tells us which sensor it is, its firmware and what failed, and never your location.